Plumbing Installation in Star, ID
Plumbing installation in Star, ID covers everything from swapping a faucet to running new lines for a remodel. Our line at (208) 679-8357 is open 24/7 for emergencies, and we book same-day appointments when available for planned work.
Tell the dispatcher what you want to add, move, or replace. We explain the scope, the permit, and the price before any pipe is cut.
- Licensed and insured
- Permit and inspection explained
- Price before work starts
- Open 24/7 for emergencies
- Licensed and insured
- Clear price before work starts
- Call to book, no forms
Smell gas? Read this before anything else
Gas safety comes first
If you smell gas, leave the building right away. Do not flip switches, use a phone inside, or light anything. Once you are outside, call the gas utility or 911 BEFORE calling a plumber.
We never promise a gas response time, because the utility and emergency crews handle the emergency. After the area is safe, call us for gas line inspection or installation. Ask the dispatcher whether your particular gas job fits our scope, and they will tell you honestly.
What we install and move
Installation work falls into a few groups, and we sort them on the first call.
Fixtures
Sinks, faucets, toilets, tubs, showers, and utility sinks, set and connected to existing shutoffs and drains.
New lines
Supply and drain runs for an added bathroom, a kitchen island, a laundry room, or a garage sink.
Relocations
Moving a fixture means moving its supply, drain, and vent, which depends on framing and slope.
Remodel rough-in
Pipe set in open walls and floors before drywall and finishes go in, then inspected.
Other related work lives on separate pages. A new heater is covered under water heater installation, and a failing fixture may be a faucet repair instead of a replacement.
Planning a relocation or remodel rough-in
A drain needs slope and a vent. A supply line needs a path to the fixture. Those two facts decide what is easy and what is expensive. Moving a sink a few feet along the same wall is usually simple. Moving a toilet across a room, over a slab, or to a second floor takes more planning.
Bring photos and a rough sketch to the call, and tell us whether the floor is slab, crawlspace, or finished basement. We would rather plan the route before you buy fixtures, because a fixture with a different rough-in size can add work.
| Project | Main questions | What it often involves |
|---|---|---|
| Swap a fixture | Is the shutoff working? Does the drain fit? | Remove, set, connect, test |
| Add a bathroom | Where are the nearest drain and supply? | New supply and drain runs, vent, and permit |
| Move a kitchen sink | Is the wall open? Where is the vent? | Re-route supply, drain, and vent |
| Basement bath | Is the slab already roughed in? | Cutting the slab for drain lines if not |
| Remodel rough-in | Are walls open yet? | Pipe set before drywall, then inspection |
Call the line. We plan the supply and drain runs first so the walls only open once.
New construction plumbing
For new construction, plumbing is built in stages that match the required inspections. Ground work comes first, before the slab or backfill. Rough-in follows, with pipe in walls and floors before they close. A final inspection finishes the job once fixtures are set. We coordinate timing with the builder so inspections do not hold up other trades.
Idaho permits, inspections, and the plumbing code
The Idaho State Plumbing Board, part of the state licensing division, adopts the 2015 Uniform Plumbing Code as the Idaho State Plumbing Code. A permit is required when any plumbing work is performed. Required inspections are ground work, rough-in, and final. Permits expire 365 days after purchase or last inspection.
Homeowners may buy a permit only for plumbing work on their own residence and related outbuildings. Plumbing contractors get permits too. A city building permit may not replace the state permit, so check with your city building department as well. Unlicensed plumbing work carries civil penalties, and you can verify any plumber at the state licensing division, (208) 334-3233.
Inspections are requested by phone at 208-334-3950 or online.
Plan the softener loop now, even if you add a softener later
An Idaho amendment to the plumbing code requires a pre-plumbed water softener loop in new one- and two-family homes built slab on grade or with a finished basement. For anyone remodeling or building in that kind of home, the practical tip is simple: put the loop in while the walls and floor are open. Adding one later means cutting into a finished wall or slab.
If you are considering treatment, our water softener and filtration page explains the options. Test your tap first to see what you actually need.
Gas line inspection and installation
Gas work needs extra care because mistakes can be dangerous. We can discuss gas line inspection and installation for appliances such as ranges and dryers. Ask the dispatcher whether your particular gas job fits our scope. If you smell gas, follow the safety block above first.
We serve Star, Middleton, and Eagle. For water leaks, see leak detection. Every new fixture, line or relocation is checked against the 2015 Uniform Plumbing Code (UPC) that Idaho adopts as its State Plumbing Code.
What affects the price of plumbing installation
- Scope of the workA fixture swap and a new bathroom are very different jobs.
- Distance to existing linesCloser connections mean less pipe and fewer holes.
- AccessOpen walls and crawlspace cost less to work in than slab or finished spaces.
- Fixtures suppliedWho buys the fixtures changes the quote, and some need special rough-in parts.
- Permit and inspectionsThey are part of the job and are listed in the price.
Insurance does not usually cover planned installation or upgrades. For your real number, call (208) 679-8357.
Plumbing installation questions from Star homeowners
Idaho requires a permit when plumbing work is performed. Homeowners can buy one only for their own residence. We explain what applies to your job on the call.
Ask the dispatcher whether your particular gas job fits our scope. If you smell gas, leave the building and call the gas utility or 911 first.
It is a set of pre-plumbed connections for a water softener. Idaho requires one in new one- and two-family homes built slab on grade or with a finished basement. Installing it early avoids opening finished surfaces later.
Idaho lets homeowners buy a permit for plumbing work on their own residence and related outbuildings, and inspections still apply. Hire a plumber for anything you are unsure about, and check any plumber's license with the state at (208) 334-3233.
Required inspections are ground work, rough-in, and final. We schedule rough-in before walls close, so plan for a short pause before drywall.
Planning plumbing work in Star?
Call (208) 679-8357. We will walk through the scope, the permit steps, and the price.
☎ Call (208) 679-8357